*Note* This product is currently order in from the Parts shop max Taiwan Factory. Roughly takes 1-2 weeks if in stock with Taiwan. You can check stock worldwide on the PSM website https://store.partsshopmax.com/ . If Taiwan is out of stock we can order from USA which may increase the price due to shipping costs from the states

Listing is for:
1x Bushing set

Anodized billet aluminum and Delrin bushing set for the OEM rack and crossmember including hardware.
Increases steering response over OEM bushings and also outlasts urethane. Perfect for use with steering angle modifications and inner toe rod forward offsetters that place additional stress on the original bushings.
Remove the OEM bushings and clean the rack’s machined bushing contact surfaces.
OEM parts may have a tighter tolerance than assistance from a dead blow hammer provides at room temp, so considering the huge range of tolerances seen in OEM parts.
If the bushings have any trouble going in, just try freezing the bushing for 30 minutes before install. Their slip fit does not require a press.
**NOTE, the rack forward crossmember center section comes with these bushings. That set uses a different hardware length and does not require the flat plate like this set designed for an unmodified crossmember.
If for some reason you own this and later move onto the center section later, you would remove these parts and sell them or make special arrangements with us to supply the CS less bushings.