Ford Falcon FG 4.0L 6 Cylinder XR6 Non Turbo Ute

$1,304.44 – $3,583.89

Complete Manta exhaust system, available in mandrel bent 2.5″ tubing. Choose between a complete exhaust system with extractors, or a “cat-back” system, replacing the last two sections of the standard exhaust.

System Type: Cat Back, Full System, with extractors
Noise Level: Medium, Quiet
Materials: Aluminised Steel, Stainless Steel
Pipe Size: 2.5in Single

Product Description

The FG Falcon was a substantial update on the previous BF model, with a completely new exterior, and an updated version of the Barra 6 cylinder motor, which in its naturally aspirated form produced up to 195kw.

The performance of this engine was nevertheless hindered by the restrictive stock exhaust system, and substantial gains can be realised by fitting a Manta Performance exhaust upgrade. The Manta exhaust system uses 2.5″ mandrel bent piping, which is perfectly matched to the Falcon’s output, giving good overall increases in power and torque, while also improving responsiveness down low.

High flow mufflers are used to control noise without impeding on performance. The full exhaust system with extractors will give the most noticeable increases in power and torque, while the cat back system is ideal if you are just looking for better sound, or a replacement for your stock exhaust system.

Manta recommends their systems be installed by a professional installer.

Ford Falcon FG FPV 5.0L Supercharged V8 Ute (all models). Exhaust exit out driver’s side.

$2,056.11 – $6,120.00

Complete Manta exhaust system, available in mandrel bent dual 2.5″ and dual 3″ tubing. Choose between a complete exhaust system with extractors, or a “cat-back” system, replacing the last two sections of the standard exhaust.

System Type: Cat Back, Full System, with extractors
Noise Level: Medium, Quiet
Materials: Aluminised Steel, Stainless Steel
Pipe Size: 2.5in Dual, 3in Dual

Product Description

The 5.0L BOSS supercharged Coyote/Miami motor in the FG FPV range was introduced when the previous 5.4L V8 could no longer meet emissions standards.

Producing a huge 335kw, the performance of this engine was nevertheless hindered by the restrictive stock exhaust system, and substantial gains can be realised by fitting a Manta Performance exhaust upgrade.

The stock headers and cats on the 5.0L FG have been proven to support over 400rwkw, and a cat back exhaust is all that’s required unless you are doing serious performance modifications. The full systems with extractors have a throatier sound, but are really only necessary if you are chasing high power figures.

High-flow straight through mufflers are used in all FG Coyote/Miami systems to control drone, while still allowing maximum performance, and giving off a deep throaty tone.

For the ultimate in power and sound, the 3″ dual system is the only one of its kind available for the Falcon, while the 2.5″ dual generally provides more than enough flow for most applications, and still sounds fantastic.

Manta recommends their systems be installed by a professional installer.

Ford Falcon FG 5.4L V8 Ute (Including XR8, FPV models). Exhaust exit out driver’s side.

$2,056.11 – $6,480.56

Complete Manta exhaust system, available in mandrel bent dual 2.5″ and dual 3″ tubing. Choose between a complete exhaust system with extractors, or a “cat-back” system, replacing the last two sections of the standard exhaust.

System Type: Cat Back, Full System, with extractors
Noise Level: Medium, Quiet
Materials: Aluminised Steel, Stainless Steel
Pipe Size: 2.5in Dual, 3in Dual

Product Description

The FG XR8 inherited the BOSS 290 5.4L V8 from the BF FPV GT, producing 290kw, while the FPV models received a tricked-up version producing 315kw. The performance of these engine was nevertheless hindered by the restrictive stock exhaust system, and substantial gains can be realised by fitting a Manta Performance exhaust upgrade. The Manta exhaust helps unleash greater peak power and torque, while also improving low-down responsiveness.

It also brings out a deep, rumbling V8 note, enhancing your driving experience, making the ute sound like it really should! There are a number of options, depending on your budget and requirements. The 2.5″ dual system sounds fantastic, with a deep throaty tone. However for the ultimate in performance and sound, the 3″ dual system can’t be beaten, being the only true dual 3″ all the way through available for the V8 Falcon.

For maximum longevity, our stainless steel systems are warranted for 10 years, and generally last the life of the vehicle, while our aluminised steel systems carry a 2 year warranty, and represent great value for money.

Manta recommends their systems be installed by a professional installer.

Ford Falcon FG 5.4L V8 Ute (Including XR8, FPV models). Optional exhaust exit out both driver & passenger side.

$2,636.67 – $7,611.11

Complete Manta exhaust system, available in mandrel bent dual 2.5″ and dual 3″ tubing. Choose between a complete exhaust system with extractors, or a “cat-back” system, replacing the last two sections of the standard exhaust. Original bumper will need modifying to suit the twin left & right outlets.

System Type: Cat Back, Full System, with extractors
Noise Level: Medium, Quiet
Materials: Aluminised Steel, Stainless Steel
Pipe Size: 2.5in Dual, 3in Dual

Product Description

The stock exhaust for the FG XR8 & FPV utes had a dual exit out the driver’s side only. However for the ultimate in looks and performance, Manta is able to offer a quad tip exhaust system, exiting out the driver and passenger side.

This system does require modification of the bumper, to allow for the extra cut-out, but the results make it more than worthwhile! The dual exit design gives the Falcon a distinctive “stereo” sound, due to each bank of cylinders exiting out separate sides of the vehicle, rather than both coming out the same side as with the stock exhaust system.

The cat back systems are ideal if you already have aftermarket headers and cats, or are just looking for improved sound, while the full systems with extractors deliver the best gains, have a throatier sound, and are essential if you are performing other engine modifications such as supercharging.

High-flow straight through mufflers are used to control drone, while still allowing maximum performance, and giving off a deep throaty tone. Everything needed to install the exhaust, including a new chassis bracket for the passenger side, is included in the package.

Manta recommends their systems be installed by a professional installer.

Ford Falcon FG FPV 5.0L Supercharged V8 Ute (all models). Optional exhaust exit out both driver & passenger side.

$2,636.67 – $7,617.22

Complete Manta exhaust system, available in mandrel bent dual 2.5″ and dual 3″ tubing. Choose between a complete exhaust system with extractors, or a “cat-back” system, replacing the last two sections of the standard exhaust. Original bumper will need modifying to suit the twin left & right outlets.

System Type: Cat Back, Full System, with extractors
Noise Level: Loud, Medium, Quiet
Materials: Aluminised Steel, Stainless Steel
Pipe Size: 2.5in Dual, 3in Dual

Product Description

The stock exhaust for the FG XR8 & FPV utes had a dual exit out the driver’s side only. However for the ultimate in looks and performance, Manta is able to offer a quad tip exhaust system, exiting out the driver and passenger side.

This system does require modification of the bumper, to allow for the extra cut-out, but the results make it more than worthwhile! The dual exit design gives the Falcon a distinctive “stereo” sound, due to each bank of cylinders exiting out separate sides of the vehicle, rather than both coming out the same side as with the stock exhaust system.

The stock headers and cats on the 5.0L Supercharged FG have been proven to support over 400rwkw, and a cat back exhaust is all that’s required unless you are doing serious performance modifications. The full systems with extractors do have a throatier sound, but are really only necessary if you are chasing high power figures.

High-flow straight through mufflers are used to control drone, while still allowing maximum performance, and giving off a deep throaty tone. Everything needed to install the exhaust, including a new chassis bracket for the passenger side, is included in the package.

Manta recommends their systems be installed by a professional installer.

Ford Falcon FG Turbo 4.0L 6 Cylinder Ute (all models inc. XR6, FPV F6)

$4,091.11 – $5,178.89

Complete Manta exhaust system, available in mandrel bent 2.5″ dual, and 3″ dual tubing. Choose between a complete exhaust system off the turbo, or a “cat-back” system, replacing the last two sections of the standard exhaust.

System Type: Full system, turbo back
Noise Level: Medium
Materials: Aluminised Steel, Stainless Steel
Pipe Size: 2.5in Dual, 3in Dual

Product Description

The FG XR6 Turbo has tremendous potential, which can quickly be unleashed with the fitment of the Manta Performance Exhaust System. The full turbo back system replaces the entire standard exhaust system, freeing up the turbo and reducing lag, whilst improving top-end performance and reducing fuel consumption due to its higher flowing design that allows the engine to operate more efficiently.

The exhaust note is much improved, allowing the whistle of the turbo to be heard. The two high-flow mufflers used ensure minimal in-cab drone, yet still maintain maximum flow and performance. For extreme applications, the dual 3″ system offers the highest flow possible, and is the only true dual 3″ exhaust system on the market for the XR6 turbo.

All 2.5″ systems are available in either stainless steel and aluminised steel, with the stainless exhaust systems carrying a 10 year warranty against manufacturing defects. In reality, a stainless system should last the life of the vehicle.

Manta recommends their systems be installed by a professional installer.

Ford Falcon FG 4.0L 6 Cylinder Non Turbo Ute (XT, XLS, 1 Ton, not XR6)

$1,188.33 – $3,675.56

Complete Manta exhaust system, available in mandrel bent 2.5″ tubing. Choose between a complete exhaust system with extractors, or a “cat-back” system, replacing the last two sections of the standard exhaust.

System Type: Cat Back, Full System, with extractors
Noise Level: Medium, Quiet
Materials: Aluminised Steel, Stainless Steel
Pipe Size: 2.5in Single

Product Description

The FG Falcon was a substantial update on the previous BF model, with a completely new exterior, and an updated version of the Barra 6 cylinder motor, which in its naturally aspirated form produced up to 195kw.

The performance of this engine was nevertheless hindered by the restrictive stock exhaust system, and substantial gains can be realised by fitting a Manta Performance exhaust upgrade. The Manta exhaust system uses 2.5″ mandrel bent piping, which is perfectly matched to the Falcon’s output, giving good overall increases in power and torque, while also improving responsiveness down low.

High flow mufflers are used to control noise without impeding on performance. The full exhaust system with extractors will give the most noticeable increases in power and torque, while the cat back system is ideal if you are just looking for better sound, or a replacement for your stock exhaust system.

Manta recommends their systems be installed by a professional installer.