GKTECH S13/180SX +39 > +74mm FRONT SUPER LOCK LOWER CONTROL ARMS (FLCA'S) (Order in)

*NOTE* Currently is an order in product from GKTECH In Australia. Takes roughly 3-4 weeks

Listing is for:
1x Pair of +39 > +74mm front lower control arms
1x Pair of S13/180sx ball joint shanks (Let us know if you need a different ball joint shank)

The new GKTECH Super Lock front lower arms are a drifters wet dream but are equally as impressive for our grip friends with 35mm of length adjustment. For drifters (aka skid racers) these lower arms will support 70 degrees of steering lock lead wheel and 65 degrees trailing wheel. They may look similar to others currently sold by other companies but are in fact unlike any other lower arms on the market.

These are the first commercially available 1 piece lower arms that work with OEM and OEM style front knuckles (such as the drop knuckles that we sell). These lower arms are based off CMM data, are CAD designed, FEA tested, have CNC machined ends and the main body is CNC Machined chromoly steel for maximum strength. To finish the arms off they're E-coated (aka electrophoresis coating) for rust prevention and we're exclusively using Teflon lined bearings including a large 3/4" outer high misalignment bearing, all with dust covers for increased longevity.

- Feature 5/8" Teflon lined sphericals (inner) and high mis-alignment 3/4 sphericals (outer) which eliminates the flex found in factory rubber bushing offering a more direct and predictable feel.
- Our V2 lower arm main body is CNC machined from a billet chromoly block with CNC machined ends.
- CMM measured, CAD designed, FEA tested and CNC machined.
- Choose from either S13/180sx tapered shank or S14/S15/R32/R33/R34 tapered shank at the time of ordering
- Choose between 2 different ball joint shank lengths; standard or +20mm to help with roll center correction.

NOTE: RC is only corrected on S-chassis', do not buy the +20mm shanks for use on Skylines.
NOTE#2: The +20mm shank with use of non RC corrected knuckles leaves very little clearance from the rotor to ball joint housing. This will be an issue in some setups when running near 0 camber.

Length Options: 
- S13/R32 adjustable from 9mm through to 44mm
- S13/R32 adjustable from 39mm through to 74mm
- S14/S15/R33/R34 adjustable from OEM length through to 35mm
- S14/S15/R33/R34 adjustable from 30mm through to 65mm

Shank Options
- S13/180sx standard length
- S13/180sx +20mm
- S14/S15 standard length
- S14/S15 +20mm

NOTE: If you are running a swaybar with the +9mm > +44mm they will only work with the Gktech link pin or others that uses a complete threaded rod and not ones like the OEM link pin that doesn't. If you plan on using the premium end links you will need to drill the hole out to suit.

NOTE: +20mm extended shank is not recommended for rims smaller than 18" in diameter and only needed on an S-chassis that is REALLY low.

NOTE: These knuckles are designed to be used with all OEM style front knuckles or modified knuckles.
NOTE#2: On R32/R33/R34 Skylines the LCA's can only be run with the use of an S chassis swaybar setup (D bushes/mount, end links and bar) Clearance Vs straight OEM style caster rods:

Suits:
C33 Laurel
CEFIRO A31
S13 CA18 180SX
S13 CA18 SILVIA
S13 SR20 180SX
S13 SR20 SILVIA