Davies Craig Electric Water Pump - EWP115 Alloy Kit 12V (Order in)

*NOTE* This product is not currently stocked in store and is Order in, it will take Roughly 5-7 working days to order in

Davies Craig Electric Water Pump - EWP115 Alloy Kit 12V (#8040)

The EWP115 (115 litres per minute) pump is suitable for small, medium, large, high- performance and 4WD vehicles. Its a performance product that improves engine cooling control and capacity whilst giving you more power and torque and improved fuel economy.

The EWP115 is a practical alternative to the mechanical belt-driven pump or fitted as an auxiliary pump. Mechanical belt-driven water pumps run directly off the motor and sap engine power the EWP115 is hardwired into your electrical system, by-passing the engine and releasing up to an additional 10kw (13hp).

- Voltage: 12 Volt Pump
- Operating voltage: 3V DC to 15V DC
- Maximum current: 10A @ 13V
- Flow rate (max): 139 L/min (36.7 US gal/min) @ 13V DC
- Operating temp.: -40 to 120C (-40 to 248F)
- Pump design: Clockwise centrifugal with volute chamber
- Pump weight: 920 grams (2.03 lb)
- Pump material: Aluminium (powder coated)
- Burst pressure: 500 kPa (72.5 psi)
- Seal: Ceramic face seal
- Self Priming: No, none of our pumps are self-priming
- Fits hose sizes: 35mm to 51mm (1 to 2) Inlet: -16AN (12) Outlet: -16AN (12)
- Push-On fitting Size: EWP Inlet and Outlet 38mm with 3mm Sleeve (#8510) 44mm with 6mm Sleeve (#8511) 51mm

Listing is for:
- EWP115 Alloy 12V x1
- EWP Basic Wiring Harness x1
- Hose Clamps x2
- RED - Wire Joiner x1
- RED - 6mm Ring Terminal x1
- RELAY - 12V 40 Amp 5 Pin W/- Resistor Protection x1
- SCREW - SELF TAP 8X3/8 BZ x1